Zone Dactylo / Typing Zone Forum Index Zone Dactylo / Typing Zone
Forum officiel / Official forum
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

The operation and maintenance of ultrafine mill

 
Post new topic   Reply to topic    Zone Dactylo / Typing Zone Forum Index -> Zone Détente
View previous topic :: View next topic  
Author Message
goldmine



Joined: 24 Aug 2019
Posts: 17

PostPosted: 12 Sep 2019 04:35    Post subject: The operation and maintenance of ultrafine mill Reply with quote

Ultrafine mill is short for ultrafine powder grinding mill, which is also called superfine mill and that is a common industrial powder making machine mainly used for making powders with and processing calcite, limestone, marble and potash feldspar. The ultrafine mill has an irreplaceable market value position in the powder making process of minerals and it also has a very long history, so that many manufacturers of mining machinery carry out plenty of improvement on the basis of traditional mills in its performance and functions. The material types that can be processed by this grinding plant is also increasing, so that it can better and more timely satisfy the specific need of customers, and this gives it bright development prospect.
1. In the using process of clinker grinding station, there should be fixed staff watching its running process and this staff should have a certain technical level. Before the installation of this powder grinding mill, the operators should be given technical training to let them learn the principle and performance of this machine to get familiar with the operation because only getting familiar with the operation procedure can this powder grinding mill be better applied in production process.
2. Before starting the superfine mill, check whether there are foreign matters such as iron inside it, tightly close the big and small observation door, adjust the rotating direction of draught fan and main engine and make sure the vent valve in the full open position.
3. The starting order should be like this: analyzer, draught fan, main engine, feeder machine, turn on the valve for blast capacity and gradually turn down the drain tap and finally adjust the fineness of final products. When stopping it, first stop material feeding for about one minute and then stop the main engine, then stop draught fan and finally stop analyzer.
4. Material feeding control: the material feeding should be even and the highest output should be tested according to the load of the main engine under different material feeding amount, and iron materials like bolt are forbidden to go inside the machine.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Zone Dactylo / Typing Zone Forum Index -> Zone Détente All times are GMT + 1 Hour
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group